Our opener circuit board replacement service in Beverly, TX comes down to three things: a clear diagnosis, the right parts on the truck, and a door that is balanced and safety-tested when we finish. Failed logic boards and receivers replaced, often after a power surge.
Signs you need opener circuit board replacement
- The opener is completely dead even though it has power
- It worked until a storm or power surge
- Random operation or no response to any control
- Diagnostic lights showing a board fault
Common causes
- Power surges and lightning
- Heat and moisture damage
- Age
Safe checks before you call
- Reset the breaker and try a different outlet.
- Unplug the opener for a minute, then plug it back in.
Still stuck? Our free symptom checker and troubleshooting wizard walk you through it step by step.
What happens during the visit
- Confirm power and rule out sensors and controls
- Replace the logic board or receiver
- Reprogram remotes
- Set the limits and force
- Recommend surge protection
On older openers, a new opener can cost about the same as a board and adds current safety and security features.
Opener Circuit Board Replacement cost in Beverly, TX
What moves the price:
- Drive type: chain, belt, screw or wall-mount
- Whether the fix is a part or a whole new opener
- Remotes, keypads and smart accessories
- Ceiling height and rail extensions
These are typical U.S. ranges, not a quote. You get an exact price for your door before any work starts. For a quick estimate, try the repair cost calculator.
Opener Circuit Board Replacement in Beverly, TX
A closed garage in a Texas summer gets very hot, which shortens the life of opener circuit boards, capacitors and photo-eye sensors. Storms add power surges, so a surge protector is cheap insurance.
Technicians serve all of Beverly (ZIP codes 76702, 76706 and 76711), plus Beverly Hills (0.7 mi), Waco (1.7 mi), Woodway (3.9 mi) and Robinson (4.3 mi). Call (833) 435-8883 to book a visit in Beverly.
Opener Circuit Board Replacement: frequently asked questions
How much does opener circuit board replacement cost in Beverly, TX?
Opener Circuit Board Replacement typically costs $175-$400 including parts and labor, and usually takes about 1 hour. The exact price depends on your door and the parts it needs, and you get it before any work starts. Call (833) 435-8883 for a quote.
Can you do opener circuit board replacement the same day?
Often, yes. When a technician is available we can usually come the same day, and common parts are carried on the truck. Doors that won't close or have a broken spring are treated as priority calls, and emergency service is available.
Is opener circuit board replacement covered by a warranty?
Our work comes with a 90-day labor warranty on repairs. New parts and doors also carry the manufacturer's warranty. Ask for the warranty details in writing with your quote.
Are your technicians licensed and insured?
Our technicians are insured, and where Texas or Beverly requires a contractor license for garage door work, the job is done under that license. You're welcome to ask for proof when you book.
Should I repair or replace my opener?
A good rule of thumb: if the repair costs more than about 50% of a replacement, or the opener is near the end of its life, replace it. Most openers last 10 to 15 years. If yours is older than that, lacks photo eyes or rolling-code security, or needs a logic board or motor, a new opener is often better value. Springs are the exception: a broken spring is always replaced, never repaired. Our free repair vs. replace calculator can help you compare.